2. Home>
  3. Forum>
  4. Support>
  5. Receiver Setup>
  6. Adding Opensky-net to an already running PiAware
×

Notice

The forum is in read only mode.

  1. Forum
  3. Support
  5. Receiver Setup
  7. Adding Opensky-net to an already running PiAware

Adding Opensky-net to an already running PiAware

5 years 11 months ago #602 by Olivier
Adding Opensky-net to an already running PiAware was created by Olivier
Hi,

I have a FlightAware setup running on a Raspberry Pi.
I would like to feed OpenSky network.
Can I add feeding to OpenSky on top of FA?

Will the install script work with no impact to FlightAware feeding?

Thank you,
Olivier
5 years 11 months ago #606 by jluebbe
Replied by jluebbe on topic Adding Opensky-net to an already running PiAware
Hi Olivier,
if you are using the official FlightAware installation you could easily add the Opensky feeder by following this guide OpenSky feeder installation guide . FlightAware performs some calculations for multilateration (MLAT) on your Raspi. If you are adding several other feeders doing the same, you may mix MLAT data causing strange results on your web interface. The OpenSky feeder doesn't perform MLAT calculations and does not disturb your system in that way.
The following user(s) said Thank You: Olivier
5 years 11 months ago #608 by Olivier
Replied by Olivier on topic Adding Opensky-net to an already running PiAware
Ok, thank you for the confirmation.

I'll give it a go over the weekend.

Olivier
5 years 11 months ago #610 by Olivier
Replied by Olivier on topic Adding Opensky-net to an already running PiAware
Just did the setup as indicated. Super easy, took 3 minutes and worked immediately.

Good job on the setup process!
  1. Forum
  3. Support
  5. Receiver Setup
  7. Adding Opensky-net to an already running PiAware
Powered by Kunena Forum