Adding Radarcape

How do I add my Radarcape to the network. If I go to my receiver profile and hit the + (plus) button I get a message saying "You are not authorised to view this resource." If I go to the add feeder section and click on add your Radarcape I get the same message.

Rich

Thanks Rich for letting us know. We're looking into the problem. Apparently it only occurs if you have more than 1 receiver...

I just wanted to add that I just upgraded the Radarcape software to the new release 2. I enabled feeding to OpenSky in the Radarcape feeder settings. The following info is noted there as well "For registration of your Radarcape on the OpenSky Network website, use MAC address xx.xx.xx.xx.xx.xx."

Rich

Hey Rich,

the problem has been fixed and the buttons now work as expected. Thanks again for taking your time to notify us and my sincere apologies for the inconvenience!

Cheers,
Marco

Hi Marco. Thanks for letting me know. All is working now. I was able to add my Radarcape. I'm glad I was able to help.

Rich

Hi just started with a Radarcape and using opensky as a data recorder etc for my unit. I have not seen though in 2 days, no collected mode s messages, mode-s message type distribuition, mode -s message counts, ads-b message type distribution, mode-s message counts. ?? I thought there might have been an issue with the mode-s receiving with the Radarcape, but I am told that because I am seeing mode-s idents for flights on my aircraft list page, the mode -s is working.

I think there was an outage at the Opensky servers, as I do not see data for the past two days on any of my 2 stations, which are in different locations

Hi orion_jb2001,

thanks for feeding to OpenSky! Your setup is fine and retrieving live data is working well. We had some problems with our storage system last week. Thus, there is a lag of ~2 days for historical data and statistics at the moment. It's being processed, but it takes a bit longer than we expected.

Markus